A Glove box regeneration usually uses a mixture of hydrogen and working gas, with a hydrogen content of 5% -10%. Glove box regeneration is to restore the water and oxygen adsorption capacity of the glove box purification column adsorption material. Each MK100 purification column requires approximately 3000-4000L (volume under standard conditions) of mixed gas. When regenerating the glove box, the main pressure range of the pressure reducing valve should be adjusted to>15Mpa, and the secondary pressure range of the pressure reducing valve should be set to 0-0.5Mpa.

A

A Glove boxes play a crucial role in nuclear material research, using specific materials and carefully designed structures to effectively block radiation from radioactive materials and isolate operators from potential radiation hazards. Through high-quality sealing technology and materials, the glove box can reduce the penetration ability of radioactive rays, strictly control the radiation dose within a safe range, and thus maximize the protection of the health and safety of operators.

A After the glove box completes the regeneration process, it usually does not automatically enter the loop mode. The main purpose of the regeneration process is to restore the adsorption capacity of purification materials such as copper catalysts and molecular sieves inside the purification column, in order to ensure a highly pure environment inside the glove box. The regeneration process usually takes about 20 hours. After the regeneration is completed, manually start the cycle to check whether the water oxygen value has effectively decreased, in order to verify whether the adsorption capacity of the purification column has been restored.

A When cleaning the Mikrouna glove box, the analyzer should be turned on, the circulation system should be turned off, and the box pressure setting should be restored to the default value, usually with an upper pressure of 6 and a lower pressure of 1. Then click the cleaning button, set the cleaning time for 30 minutes, and click start cleaning. After 30 minutes, the cleaning will automatically end. If the oxygen level in the box is not lower than 100ppm after the automatic end, the cleaning can be repeated; If the oxygen level in the box has dropped below 100ppm within 30 minutes, the cleaning can be manually turned off.

A The glove box can be equipped with a control system that can accurately adjust environmental factors such as temperature, humidity, and light. By adjusting these factors, the growth environment of plants in different seasons or ecological conditions can be simulated to meet the needs of different plant tissue cultures, providing suitable environmental conditions for plant tissue cultures and improving the reproducibility and accuracy of experiments.

A When taking out items, forgetting to vacuum the transition chamber and opening it directly can cause the air inside the transition chamber to enter the glove box, causing the water and oxygen levels inside the box to rise. If this is done during the experiment, the increase in water and oxygen levels may affect the accuracy of the experimental results. It is recommended to stop the experiment and open the glove box for 20-30 minutes to quickly replace the gas inside the box. After reducing the water and oxygen levels, start the glove box cycle again until the water and oxygen levels reach the set standards, and then restart the experiment.

A